PumpLink
Secure fire-pump control and monitoring
Fire Pump
No active fault
Monitoring only — commands to this hardware controller are disabled.
Diagnostic snapshot
Press Diagnostic snapshot above to capture the current controller readings.
Connection and reading age
Pump packet and battery reading ages are not available from the current controller firmware. A recent Control connection does not prove a new Pump packet was received.
Installed firmware
Older Pump firmware remains compatible but may show “Not reported”. Firmware source code cannot be read back from an UNO.
Recent activity (last 10)
Settings
Change my password
Install PumpLink on this phone
Checking this connection…
Install PumpLink from this secure page to open it from your home screen like an app.
Add my pre-programmed controller
Create a one-time setup code, connect your phone to the controller's PumpLink Setup Wi-Fi, then open http://192.168.4.1. Enter the code, home Wi-Fi, and the LoRa pair ID and sync word printed on the existing Pump UNO/controller label. A replacement controller can then join the existing Pump without reprogramming it. Use this PumpLink server address:
Accept a controller invitation
Enter the single-use code supplied by the controller owner.
My controllers
Owners can invite family members or permanently remove a controller. Removing it revokes the controller credential and requires a physical setup reset before it can be added again.
Users
Create an account for a family member, then give them access to a controller below. They can also create their own account on the sign-in screen.
Deleting a user signs them out and removes all access. Sole controller owners must transfer or delete their controller first.
Who can use each controller
Choose a user and controller. Operator can control a supported pump; Monitor can view readings only. Changes to an existing assignment take effect at the next refresh.